What's New


Blog


«February 2018»
MonTueWedThuFriSatSun
2930311234
567891011
12131415161718
19202122232425
2627281234
567891011

EHELP: SPA Power Consumption

EHELP: SPA Power Consumption

Q:  We are considering ordering the Moore Industries SPA/0-100mV/2 PRG/U/-SOL [DIN]. Can we power it using 24VDC? If so, what is the power consumption and how do we terminate? Also, can you please confirm whether this unit is Class 1 Div2, group A,B,C,D?

Published: September 13, 2016

EHELP: SPA2 Tank Application

EHELP: SPA2 Tank Application

Q:  Do you have a signal alarm unit for a tank level application? I need it to meet the following requirements:

  • Input signal accepts 4-20mA.
  • Contacts opened or relay de-energized @ EL 208 ft.
  • Equipped with up to four alarm trip relays.  
  • Individually configured for: set point, high or low trip, normally open or normally close, failsafe or non-failsafe, and latching or non-latching.
  • ■ Deadbands adjustable over 100% of span.
  • ■ Output relay equipped with form C contacts rated at 10A, 120VAC.
  • ■ All operating parameters adjustable from the front panel keypad.
  • ■ Operate on a 120V 60 Hz power source
  • ■ Capable of supplying 24V dc power to two-wire transmitters.
Published: August 23, 2016

E-HELP: FDY Frequency-to-DC Converter Options for Class I, Div 2 Locations

E-HELP: FDY Frequency-to-DC Converter Options for Class I, Div 2 Locations

Q: I would like to use either FDY/PRG/4-20MA/12-42DC [HPDN] or FDY/PRG/4-20MA/12-42DC [BH2NG] and I want to install it in a control panel enclosure rated Type 4X. I need to ensure it is suitable for Class I, Div 2. Which one is the best solution? 

Published: August 16, 2016

EHELP: HIX Minimum Output Value

EHELP: HIX Minimum Output Value

Q:  HIX Application - It appears that if the "Primary Master" loop (input loop side of the HIX) is broken or open circuited, the "Secondary" loop (output loop side of the HIX) will be 0mA.   Is this true?  Maybe I can put a zener across the primary process terminals to keep the current loop when the process opens? Also, are both or either loops bi-directional HART? I have a 4-20mA input signal that I'd like to share between two 4-20mA/HART process loops. Actually, we currently use another vendor's device to "split" one 4-20mA input to four process loops but it doesn't pass HART.

Published: August 9, 2016

EHELP: Temperature Measurements in Liquid

EHELP: Temperature Measurements in Liquid

Q: We want three 100 ohm, .00385 Alpha RTDs to measure heated glucose in railroad cars. We heat the glucose to 140-150°F, and want to use a 5-foot long flexible sensor with a head on top containing a terminal strip. We also want to run flexible conduit from the head with copper wire for easy replacement access. We can fabricate a bracket that would span the midway above the railcar that supports the housings and includes holes that allow the flexible RTDs to drop down for installation. What do you offer that is a fit for our application?

Published: June 28, 2016
RSS
First 234567891011 Last