What's New


Blog


«February 2018»
MonTueWedThuFriSatSun
2930311234
567891011
12131415161718
19202122232425
2627281234
567891011

Temperature Measurement Solutions:

Getting Ambient Temperature Measurements

Temperature Measurement Solutions:

Measuring ambient temperatures is a common application with a number of solutions depending upon your use of the word “ambient”.

Published: October 19, 2016

Temperature Q&A With JR Madden: Isolated Measuring Circuit and Ungrounded Thermocouple

Temperature Q&A With JR Madden: Isolated Measuring Circuit and Ungrounded Thermocouple
Q: Why Do I Need to Use an Isolated Measuring Circuit When Using and Ungrounded Thermocouple?
Published: September 14, 2016

Bearing Oil Sensor For High Vibration Environments

Bearing Oil Sensor For High Vibration Environments

A compressor at a chemical company vibrated severely – a common problem with compressors in any industry. An important sensor used to measure the compressor’s bearing oil temperature was a field-cuttable RTD that failed frequently, forcing a compressor shutdown each time. The Moore Industries WORM Flexible Temperature Sensors solved the problem.

Published: September 10, 2016

Donation Aids in Restoration of World War II PT Boat

Donation Aids in Restoration of World War II PT Boat

Moore Industries is doing its part to get an historic World War II boat back in the water. We've recently donated products that will help The National WWII Museum in New Orleans to restore a classic Higgins Industries PT (Patrol Torpedo) boat and make it seaworthy again.

Published: September 6, 2016

Temperature Q&A with JR Madden: Flexible RTD Sensors Needed for Cold and Hot Fluid Lines

Temperature Q&A with JR Madden: Flexible RTD Sensors Needed for Cold and Hot Fluid Lines
Q: I have a project for six RTD measurements that makes using standard fixed length sensors difficult because there is little clearance near the top of the thermowell for sensor insertion.  It looks like your “WORM Sensor” would be an ideal fit for the application because of its flexible design.  These RTD sensors need to be 100 or 1000 ohm platinum elements with Class A or 1/3 DIN accuracy ratings. They will be used to monitor chilled and hot water lines with min and max temperature limits of 30 F and 180 F.  Maximum insertion length in these ¼ inch ID thermowells is about 10 inches.  I noticed that your standard WORM length is 24 or 36 inches.  Are custom length WORM sensors available?  If so, what cost is associated with ordering multiple sensors at custom lengths?  Lastly, we usually request test data with all of our sensors and check them in our air bath or heat block calibration units.  Can you offer a test report or test data points with these WORM sensors?
Published: August 3, 2016
RSS
12345678910 Last