What's New


Blog


«December 2017»
MonTueWedThuFriSatSun
27282930123
45678910
11121314151617
18192021222324
25262728293031
1234567

E-HELP: FDY Frequency-to-DC Converter Options for Class I, Div 2 Locations

E-HELP: FDY Frequency-to-DC Converter Options for Class I, Div 2 Locations

Q: I would like to use either FDY/PRG/4-20MA/12-42DC [HPDN] or FDY/PRG/4-20MA/12-42DC [BH2NG] and I want to install it in a control panel enclosure rated Type 4X. I need to ensure it is suitable for Class I, Div 2. Which one is the best solution? 

Published: August 16, 2016

Video Highlights HCS Natural Gas and Oil Wellhead Applications

Video Highlights HCS Natural Gas and Oil Wellhead Applications

If you are involved in the production of natural gas and oil, you understand the challenge of providing power for monitoring and control instrumentation at site locations with limited power resources. One way to combat this is with the use of the HCS HART® Concentrator System from Moore Industries. Watch a video that shows how the HCS saves money and time by consolidating wiring and reducing power consumption at remote natural gas and oil production sites.

Published: August 11, 2016

New and Improved: "Alarm Trips: The Ups and Downs" Technical Paper

New and Improved: "Alarm Trips: The Ups and Downs" Technical Paper

Nowadays just having an effective alarm trip solution may not be enough.  Pushing forward in ways to protect life, community, environment and facilities, the process industry is experiencing dramatic increases in the need for functionally safe solutions. Moore Industries’ technical paper Alarm Trips: The Ups and Downs has been expanded with added material on this topic and more.


Published: August 8, 2016

Temperature Q&A with JR Madden: Flexible RTD Sensors Needed for Cold and Hot Fluid Lines

Temperature Q&A with JR Madden: Flexible RTD Sensors Needed for Cold and Hot Fluid Lines
Q: I have a project for six RTD measurements that makes using standard fixed length sensors difficult because there is little clearance near the top of the thermowell for sensor insertion.  It looks like your “WORM Sensor” would be an ideal fit for the application because of its flexible design.  These RTD sensors need to be 100 or 1000 ohm platinum elements with Class A or 1/3 DIN accuracy ratings. They will be used to monitor chilled and hot water lines with min and max temperature limits of 30 F and 180 F.  Maximum insertion length in these ¼ inch ID thermowells is about 10 inches.  I noticed that your standard WORM length is 24 or 36 inches.  Are custom length WORM sensors available?  If so, what cost is associated with ordering multiple sensors at custom lengths?  Lastly, we usually request test data with all of our sensors and check them in our air bath or heat block calibration units.  Can you offer a test report or test data points with these WORM sensors?
Published: August 3, 2016

NCS Skids Installed in DOE Hanford Site Sludge Treatment Project

NCS Skids Installed in DOE Hanford Site Sludge Treatment Project

At the Hanford Site KW-Basin Sludge Treatment Project in southeastern Washington, the Department of Energy (DOE) employs multiple NCS Net Concentrator Systems to automate communications among numerous sludge conversion process skids. 

Published: June 29, 2016
RSS
12345678910 Last